Grinding Spindles Repaired

• Air-oil or oil mist lubrication systems
• Ball bearing-mounted
• Internal grinding spindle specifications: from 60mm to 120 mm body diameters
• Grinding spindle attachment types: Cylindrical front attachment, over scaled cylindrical front attachment, male tapered front attachment, male tapered front attachment for deep holes.
• Hydrodynamic bearing mounted
• External grinding spindles specifications: Angular contact bearings and hydrostatic bearings
• Center-less grinding spindles
• Deep hole grinding spindles
• High frequency spindles: we meet all internal grinding requirements and specifications
• Components hardened to prevent wear and loss of precision, rotating parts dynamically balanced, and use steel and ceramic bearings
  
  

GTI’s Spindle Service Process

• High performance acoustic control sensors monitor acoustic emissions from your grinding spindles resulting in higher grinding accuracy, efficiency and reduced machine wear.
• Dittel GAP-R GA: Reduces contact control unit measures structure-borne noise directly on the shaft of the grinding wheel (internal and external grinders) or dressing roller.
• GAP 3000 and GAP 5000: Both are directly applicable to OD, ID and surface grinders and are used to control “GAP” eliminate, change feed rate as required, initiate dress feed or continue dress, and act as crash prevention. The GAP 5000 also incorporates an automatic wheel balancer.
  
  

We are a trusted sales and service representative for Walter Dittel GmbH, U.S. manufacturer of advanced integrated Acoustic Control Systems, Balance Control Systems and Process Control Systems precision grinding spindles and equipment.

Dittel Acoustic Control Systems – Operational Benefits

• Low cost
• Increased crash control
• Reduced in “air grinding” time
• Reduced dressing time
• Reduced Wheel Wear
• User-friendly installation
• High performance acoustic control sensors monitor acoustic emissions from your grinding spindles resulting in higher grinding accuracy, efficiency and reduced machine wear.
• Dittel GAP-R GA: Reduces contact control unit measures structure-borne noise directly on the shaft of the grinding wheel (internal and external grinders) or dressing roller.
• GAP 3000 and GAP 5000: Both are directly applicable to OD, ID and surface grinders and are used to control “GAP” eliminate, change feed rate as required, initiate dress feed or continue dress, and act as crash prevention. The GAP 5000 also incorporates an automatic wheel balancer.
  
  

We provide spindle service for the following Dittel Systems: